Steps To Install a Garage Door Opener
After selecting a Garage Door Opener Flower Mound that would suit your garage and garage door, the next important thing is to ensure that it is safely installed. Improper installation can damage the mechanism of the opener leading to faulty operations.
Parts of a Garage Door Opener
It is common among garage door openers to have a rail or tube which runs the carriage and connect it from the motor to the garage front, while an arm connects it to the door of the garage. The carriage is connected either by a chain or a rod depending on the type of opener it is.
Installing Garage Door Openers
The installation of a garage door opener takes only a few hours and is a moderately challenging task. You should get experts to install the opener if you are not an expert in mechanical tasks.
Assembling the Carriage Tube
Once you have all the parts of the garage door opener, assemble them according to the instructions given in the manual. Arrange the pieces of the carriage tube properly and measure the length to ensure it is the same as specified.
Mounting the Carriage Tube
The carriage is then mounted to the power unit of the garage door and the carriage tube to the front of the power unit. The rail clamps also need to be attached at this step. You should also install the switches and wiring.
Carriage Needs to be Slipped Over the Tube
The carriage is then slipped over the carriage tube according to the directions of the manufacturer. Remember that different makes and models may attach differently.
Header Bracket Should be Mounted Next
The header bracket is the garage door opener mounting bracket. It secures the carriage tube to the wall. The place of mounting it depends on the type of garage door. An Overhead door Flower Mound tx would have the header bracket in one place while the others may have it in another.
Hang the Power Unit From Ceiling
The angle irons are then attached to rafters by using lag screws. Most units hang from these angle irons. Then the various straps to the irons and power unit are attached. Once done, test it several times before moving to the next step.
The Bracket to Connect the Arm Needs to be Attached
First, you need to attach the bracket that connects the arm to the door. After this, you need to attach the arm itself. Again, the location of attaching the bracket varies according to the garage door. You should follow the instructions of the manufacturer properly in this step.
Plug it in
Finally, most of the installation process is over. You need to plug the garage door opener Flower Mound, to the socket and check the operations a few times to ensure that it is working properly.
The units are equipped with a safety device to shut down the motor in case something causes an obstruction in the path of the closing door. Be sure to check if this feature is functional or not.
In case of replacing the garage door opener, be sure to remove the mechanism of the old opener before starting the installation of the new. Do not consider reusing parts of the old opener. Maintain the opener by regularly cleaning the tracks and lubricating them with lithium-based grease.
Need garage door repair services in Flower Mound, Tx, do let us know in the comment section below.
Comments
Post a Comment